Publicidad
Idiomas disponibles
Idiomas disponibles
HEADLIGHT REPLACEMENT
See Figure 21.
Call customer service or visit our website online to order a new
headlight.
Park the mower on a level surface and set the parking brake.
Stop the motor and remove the start key.
Remove and set aside the hex head screw and flat washer
holding the mower floor panel in place.
Lift floor panel slightly to access the two hex head screws
and flat washers securing the headlight in place. Remove
screws and washers and set aside.
Unplug the old headlight and discard.
Plug in new headlight and reinstall washers and screws.
Tighten securely.
Lower floor panel and reinstall washer and screw to secure.
LEVELING THE CUTTING DECK
See Figures 22 - 23.
If your lawn appears unevenly cut after using the mower, the
cutting deck may need adjusting. Before deciding that level-
ing the cutting deck is necessary, make sure tires are properly
inflated to the recommended PSI when mowing. Over- or under-
inflated tires can affect the appearance of the cut, and proper
inflation of the tires may be all that is needed to resolve uneven
cutting issues.
NOTE: Always check side-to-side alignment and adjust as
needed before measuring and adjusting front to back.
Before beginning:
Make sure direction control switch is in neutral (N) position
and blade engage knob is down.
Stop the motor, allow the blades to come to a complete
stop, remove the start key, and set the parking brake.
Raise the height of the cutting deck to its highest position.
To make side-to-side adjustment:
Position the blades so that the ends point toward the sides
of the mower.
On the outside edge of each blade, measure the distance
from the bottom edge of the side of the blade to the ground.
If the distance between the two sides is greater than 1/8 in.,
a side-to-side adjustment is necessary.
On the side you wish to adjust, loosen the jam nuts as shown.
Turn the adjustment nuts clockwise to raise or counterclock-
wise to lower the side of the cutting deck. Each full turn of
the adjustment nut will change the deck height approximately
3/16 in.
NOTE: If raising the side, you will need to turn the top ad-
justment nut first. If lowering, turn the bottom nut first.
Measure again. Continue to adjust and measure until the
difference between the distance on each side is 1/8 in. or
less.
Proceed to front-to-back adjustment or retighten jam nuts
to secure.
To make front-to-back adjustment:
NOTE: Always level the deck side to side before making a front
to back adjustment.
MAINTENANCE
BOTTOM EDGE
JAM NUT
ADJUSTMENT
NUTS
JAM NUT
24 — English
HEX KEY
SCREWS
WASHERS
HEADLIGHT
BLADE
Fig. 21
Fig. 22
Fig. 23
Publicidad
