Yard force YF1800LR Manual De Referencia página 22

Pump is noisy.
Water leaks from pump
(up to 10 drops per min-
ute is permissible).
Oil is dripping.
Motor buzzes but fails to
run.
Motor buzzes but fails to
run. (continued)
No water.
If you have any questions, visit our website for key FAQ's, downloadable
troubleshooting steps, instructional videos, and replacement parts purchase at www.
ForceToolsUSA.com, or call our toll free hotline: 1-866- 902-9690.
Pump is sucking air.
Water filter is clogged.
Loose fittings.
Water seals are damaged
or worn.
Oil seals are damaged or
worn.
Supply voltage below
minimum.
System has residual pres-
sure.
Voltage loss due to exten-
sion cord.
Pressure washer not used
for long periods.
Residual friction among
components. Unit might
hum.
Water supply is OFF.
Kink in the garden hose.
21
Check that hoses and
fittings are airtight. Turn off
machine and purge
pump by squeezing trigger
gun until a steady flow of
water emerges through the
nozzle.
Remove water filter and
rinse in warm water.
Check that all fittings are
tight.
Call the Toll-Free Hotline.
Call the Toll-Free Hotline.
Verify that only the pres-
sure washer is running on
this circuit.
Turn unit OFF, squeeze
trigger on spray wand to
release pressure, then turn
unit ON.
Unplug any extension
cords attached and plug
the unit directly into the
outlet.
Call the Toll-Free Hotline.
Disconnect water supply
and power ON for 2 to 3
seconds, repeat couple
times or until the motor
starts.
Turn ON water supply.
Remove kink in garden
hose.