Lenco MC-250 Manual Del Usuario página 24

Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor signal-to-noise
ratio (hiss) from weak stations. To change the scan setting to stop only at stations with good
signal strength, select Menu > Scan setting > Strong stations only? > Yes
Audio Settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a
poor signal-to-noise ratio (hiss). To play weak stations in mono, select Menu > Audio
setting > FM weak reception: Listen in mono only > Yes.
Station Recall:
After preset completed, press the MEMORY button or the Preset button to recall the stored
station, press the OK knob or the OK button to listen to the selected station.
When Scan is selected, the unit will scan and store the available station automatically.
When Manual tune is selected, there will be a list of certain frequency, select one and play.
When Prune invalid is selected, there will remove all invalid stations from list.
Select "YES" to remove all invalid stations, select "NO" to cancel.
When DRC is selected, set it to DRC high, DRC low or DRC off.
There are 3 levels of compression:
DRC Off - no compression. This is the default setting.
DRC Low - medium compression.
DRC High - maximum compression.
When Station order is selected, set it to Alphanumeric, Ensemble or Valid.
NOTE: If the reception is weak, please unwind or extend the telescopic antenna, or relocate
the unit to get better reception
FM Mode:
In Main menu, if FM is selected, the following page will appear.
24