(control)
(black)
(manual)
(colour)
(chase)
(sound)
(other)
Remarks:
•
When no DMX data is received, the display will flash.
•
The 'scene' speed is the time during which a scene is shown. The 'fade' speed is then the time
it takes to switch to a next scene. E.g. when projecting full red, full green and full blue in
sequence, with both 'scene' and 'fade' speed set to 1 second:
second 1: full red scene
second 2: red fades from 100% to 0% while green raises from 0% to 100%
second 3: full green scene
second 4: green fades from 100% to 0% while blue raises from 0% to 100%
second 5: full blue scene
second 6: blue fades from 100% to 0% while red raises from 0% to 100%
...
19/06/2009
VDPLW1203RGB
Set the VDPLW1203RGB in 'master' mode.
Set the VDPLW1203RGB in 'stand-alone' mode (default).
Select the blackout function.
Set value for RED LED (r000~r255, default r255)
Set value for GREEN LED (g000~g255, default g255)
Set value for BLUE LED (b000~b255, default b255)
Set value for STROBE function (0~255, default 000)
Set 'scene' speed (001~255) (see remarks below).
Set 'fade' speed (001~255) (see remarks below).
Set 'strobe' speed (000~255).
Set 'scene' speed (001~255).
Set 'fade' speed (001~255).
Set 'strobe' speed (000~255).
Set 'scene' speed (001~255).
Set 'fade' speed (001~255).
Set 'strobe' speed (000~255).
Set 'scene' speed (001~255).
Set 'fade' speed (001~255).
Set 'strobe' speed (000~255).
Set 'scene' speed (001~255).
Set 'fade' speed (001~255).
Set 'strobe' speed (000~255).
Set 'scene' speed (001~255).
Set 'fade' speed (001~255).
Set 'strobe' speed (000~255).
Set 'scene' speed (001~255).
Set 'fade' speed (001~255).
Set 'strobe' speed (000~255).
Set 'scene' speed (001~255).
Set 'fade' speed (001~255).
Set 'strobe' speed (000~255).
Sound controlled run as master.
Sound controlled run as stand-alone.
Set microphone sensitivity (000-099, default 070)
Select 'standard' dimming (default).
Select 'linear' dimming.
Reset the device to factory defaults.
Show the firmware version (V x.x)
7
Rev. 01
© 2009 Velleman nv