Haier HDR3619FN Serie Manual página 31

GB
10.9 Door Reversibility
Before connecting the appliance to the power supply you should check, whether the door
swing must changed from right (as delivered) to left, if this is required by the installation
location and the usability.
WARNING!
▶ The appliance is heavy. You need two persons to carry out the door reversibility.
▶ Before any operation, first unplug the appliance from the mains .
▶ Do not tilt the appliance more than 45 ° to prevent damage of the cooling system.
Assembly steps
(Fig. 10.9):
1. Provide necessary tool.
2. Unplug the appliance.
3. Remove the five screws which fix the front panel
(1) and remove the panel (2).
4. Remove the small cover of the front panel from
left to right side.
5. Unplug the connection cable
6. Remove the upper hinge cover (1) and unscrew
the upper hinge (three screws) on right side (2).
7. Lift the loose refrigerator door carefully off the
lower hinge.
8. Turn the door upside down, unscrew the cover (1)
and the door stop (2) with fixing part (3).
9. Take out new cover (1) and door stop (2) with fixing
part (3) from the accessory bag and screw them
to opposite side.
10. Remove the lower hinge of the upper door.
11. Change the positions of the blanking plugs and
the screw on the side.
10- Installation
1.
3.
1
2
5.
7.
2.
10.9
4.
6.
1
2
10.
11.
31