Speaker Connection - Teac A-H01 Manual Del Usuario

Speaker Connection

Right Speaker
CAUTION before connection
< After all other connections are complete,
connect the power cord's plug to the wall
socket .
< Read the instructions of each device that you
intend to use with this unit .
Caution
< Check the impedance of your speakers .
Connect speakers with an impedance of
between 4 ohms and 8 ohms .
< The red speaker terminals are + (positive) and
the black speaker terminals are – (negative) .
Generally, the + side of the speaker cable is
marked to make it distinguishable from the
– side of the cable . Connect the marked side
to the + terminal and the unmarked side to
the black – terminal .
< The metal portions of the two separate wires
should not touch or an electrical short may
occur . Shorted wires can create a fire hazard
or induce a failure in your equipment .
< Be sure to insert each plug securely . To
prevent hum and noise, avoid bundling the
cables together with the AC power cord or
other cables .
8
Left Speaker
How to connect:
Turn the terminal cap counterclockwise
1
to loosen it. The speaker terminal caps
cannot be fully removed from the
product.
Insert the wire into the terminal and
2
turn the terminal cap clockwise to
securely connect it:
< Make sure none of the wire insulation is
under the terminal and only the bare,
stripped wire is touching the terminal .
Make sure the cable is fastened firmly
3
by pulling the cable lightly.