Yamaha RX-485 RDS Manual De Instrucciones página 11

TO RECORD A SOURCE TO TAPE
RX-485 RDS
1
Select the source to be recorded.
MONITOR
TAPE 2 TAPE 1
COPY
* To dub from tape to tape, refer to the "Notes" shown
below.
* When you select AUX, TUNER, CD or PHONO, be sure
that TAPE 1 and/or TAPE 2 are not also selected.
2
Play the source and then turn the VOLUME control up
to confirm the input source. (For detailed information
on the tuning operations, refer to the page 12.)
3
Begin recording on the tape deck.
4
To monitor the audio signals being recorded, press the
input selector button for the tape deck being used to
make the recording.
MONITOR
TAPE 2 TAPE 1
COPY
Notes
VOLUME, BASS, TREBLE, BALANCE and LOUDNESS
control settings have no effect on the material being
recorded.
To dub from tape to tape, only the following method of
dubbing can be performed.
SOURCE
Tape deck connected to
the TAPE 2 terminals.
10
INPUT
AUX TUNER CD PHONO
INPUT
AUX TUNER CD PHONO
RECORDER
Tape deck connected to
→
the TAPE 1 terminals.
1, 4
TO RECORD A SOURCE TO TAPE
RX-385, RX-385 RDS
1
Select the source to be recorded.
TAPE
MONITOR AUX
* When you select AUX, TUNER, CD or PHONO, be sure
that TAPE MONITOR is not also selected.
2
Play the source and then turn the VOLUME control up
to confirm the input source. (For detailed information
on the tuning operations, refer to the page 12.)
3
Begin recording on the tape deck.
4
To monitor the audio signals being recorded, press the
TAPE MONITOR.
TAPE
MONITOR AUX
Note
VOLUME, BASS, TREBLE, BALANCE and LOUDNESS
control settings have no effect on the material being recorded.
2
INPUT
CD PHONO
TUNER
INPUT
TUNER CD PHONO