Publicidad
To turn the unit into the PS mode or PTY mode
Press the FREQ/PS/PTY button. Whenever pressed, the mode changes into the PS mode, PTY mode and returns to usual mode in
turn.
* When an RDS station is received, the display is automatically turned into the PS mode. Do not press the FREQ/PS/PTY button
until the display is turned into the PS mode. If the button is pressed before the display mode is changed, it may occur that "NO
PS" flashes on the display. This is because the unit has not received all of the RDS data on the station yet.
PS/PTY SEEK
FREQ/PS/PTY
SHIFT
ENTER
Note
When PS or PTY data reception is not possible due to poor reception conditions, "NO PS" or "NO PTY" flashes on the display in
each mode. In such a case, press the TUNING MODE button so that "AUTO TUNING" goes off from the display. Though the
reception mode is changed to monaural by this operation, when you changes to the PS or PTY mode, PS or PTY data may be
displayed.
PS mode
The name of the station being received is displayed.
If the station is not an RDS station, "NO PS" flashes on the
display and then returns to usual mode.
PTY mode
A program type for the station being received is displayed.
If the RDS station does not employ the PTY data service,
"NO PTY" flashes on the display and then returns to the PS
mode.
If the station is not an RDS station, "NO PTY" flashes on the
display and then returns to usual mode.
Usual mode
The frequency of the station being received is displayed.
17
Publicidad
