Before Installation; Cleaning And Care - LIVARNO LUX HG00099A Instrucciones De Montaje Y De Advertencias De Seguridad

Before installation

Important: The electrical connection must be
performed by a qualified electrician or a person
trained in electrical installations. This person must
be familiar with the properties of the light and the
connection regulations.
Before installation ensure that the circuit, to
which the light will be connected, is not ener-
gised. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (
Use the voltage tester to verify the de-energised
status.
The included mounting material is suitable for
ordinary solid concrete or masonry construction.
Check whether the mounting material is suitable
for your chosen mounting surface. Also check
whether the chosen mounting surface is suitable
for supporting the lamp. If necessary, seek ex-
pert advice.
Installation
Note: the installation steps are identical for all the
lamp models mentioned in these instructions.
Hold the housing of the light
and mark the drill holes (see fig. A).
Now drill the mounting holes (Ø 6 mm). Ensure
that you do not damage the supply line.
Insert the dowels
1
Then pull the fabric tube
the external main power lead
Connect the terminal block
the strands of the external main power lead
(see fig. C). Pay attention to the markings on
the terminal block (L for live, N for Neutral).
Then secure the lamp housing
using the screws
6
Attach the protective caps
in the lamp casing (see Fig. E).
After the fuse has been inserted or the circuit breaker
is engaged in the fuse panel, your lamp is ready
for use.
0 position)
against ceiling
4
into the holes.
over the strands of
3
(see fig. B).
2
of the lamp with
5
to the ceiling
4
(see fig. D).
to the openings
7
Directing the spotlights
The spotlights
8
vertically and approx. 330° horizontally in order to
place targeted light accents (see fig. E).
WARNING: The spotlights become hot during
operation. Switch them off and allow to cool down
for at least 5 minutes before touching them.

Cleaning and Care

.
Before cleaning and caring for your lamp, disconnect
the lamp from the mains (remove the fuse or disable
the circuit breaker in the fuse panel - 0-position) and
let it cool for at least 5 minutes!
For electrical safety, never clean the light with water
or other fluids, or immerse it in water.
Do not use solvents, petrol etc. Otherwise the
light will be damaged.
Use a dry fluff-free cloth when cleaning.
Disposal
The packaging is made of environmen-
tally friendly materials, which may be
disposed through your local recycling
facilities.
Contact your local authorities for information on
how to dispose of the product at the end of the
product's life.
Never dispose of the product in your regular house-
hold rubbish.
The device / article should be disposed
of at an officially approved disposal cen-
tre or at your local communal disposal
facility.
Observe the applicable regulations. In case of doubt,
please contact your waste disposal centre.
can be adjusted to approx. 90°
GB/MT 15