Publicidad
Idiomas disponibles
Idiomas disponibles
Fit the foot rails
A
(
)
Using a panel tool or flat screwdriver,
remove the two covers found in the Ditch
Moulding on each side of the vehicle's roof.
B
(
)
Place a small amount of silicone around each of the Threaded Mounting Points found below the covers
removed in Step 2A. Place a Spacer (Item 9) into each ditch as shown, lining up the hole in the Spacer
with the Threaded Mounting Point.
( C )
Place the Foot Rails onto the Spacers, lining
up the holes in the base of the Foot Rails
with the slots in the Spacers. The Product
Sticker goes to the front of the vehicle and
must face outwards.
REV_A01
3
Publicidad
