Publicidad
Idiomas disponibles
Idiomas disponibles
FIT THE RACK cont...
3
B
(
)
With your Rack still upside down from Step 4A, slide a M8 x 20 Hex Bolt (Item 1) into each end of Slats 2,
6 & 7. Place a M8 Flat Washer and M8 Nyloc Nut (Items 2 & 3) onto each bolt. Hand tighten the Nyloc Nuts
until they begin to take on the nylon.
Grab your Friend and with one of you on each side of the Rack, flip the Rack end over end so that the M8
x20 Hex Bolts are facing down. Approach the vehicle from the rear, with the Wind Deflector facing
forward. Lift the Rack up an over the Roof positioning it above the Foot Rails. Bring the Rack down slowly,
lining up the Bolts in the Rack with the slots in the top of the Foot Rails.
Slide the Hex Bolts into the Slots on the Foot Rails, making sure that the Flat Washer and Nyloc Nut sit
below the Foot Rail and that the Bolt is all the way in the Slot as shown below and loosely tighten. Ensure
that the Rack is still able to move left to right.
( C )
Using a tape measure, center the Rack - left to right. Fasten all the Nyloc Nuts securing the Rack to the
Foot Rails. To complete the installation, place the M8 Nut Caps (Item 4) supplied over all the Nyloc Nuts.
REV_A01
5
Publicidad
