Whittier Wood Products 82W Instrucciones Para Armar página 4

Phillips Head Screwdriver, Wood Glue, Rubber Mallet or Padded Hammer.
E
FIG. 1
1) Lay out the Back-Top (A), Back-Middle (B), Back-Bottom (C), and Back Stretcher (D) in their approxi-
mate positions between the Left Back Leg (E) and the Right Back Leg (F). Note that the longer back
pieces are near the top of the back leg and the shorter pieces near the bottom. See FIGURE 1.
Spread glue evenly in the three slotted holes and the one round hole in the side of each Back Leg
(E & F). Starting at the top of one back leg, insert the Back-Top (A), Back-Middle (B), Back-Bottom
(C), and Back Stretcher (D). Now insert the back pieces in the other back leg. It is important that all
the back pieces (A, B & C) are fi rmly and completely seated in both back legs and their shoulders
must be against the back leg.
O
x 2
2) To hold the back leg assembly together while the glue dries, use a
piece of rope approximately fi ve feet long. Wrap the rope loosely
around the back assembly near the center of the back legs (protect
the back legs with cardboard or cloth) and tie the ends in a square
knot. Loop the rope around a dowel or screwdriver and twist until
tight. Tie down as shown in FIGURE 2. Leave rope in place at least
one hour.
Insert a #8 x 1¼" Pan Head Screw (O) through the holes in the outside edge of each back leg into
the Back-Top and fasten securely. See FIGURE 2.
PAGE 4 — 82W
82W Provence Chair
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED:
D
C
B
A
F
O
FIG. 2
IMPORTANT:
READ GLUING HINTS
BEFORE ASSEMBLING!
SHOULDER
O