Avanti NIMD3313S-IS Manual De Instrucciones página 11

CAUTION: Failure to unplug the ice maker could result in electrical shock or personal injury.
 Cleaning Your Ice Maker
Before using your ice maker, it is strongly recommended that you clean it thoroughly.
To ensure the cleanliness of the ice cubes, it is recommended that you use filtered water.
•
• Remove the ice basket.
Remove the drain cap to drain remaining water from the water reservoir when the ice maker will not be
•
used for long period of time. Put the drain cap back in place after the water has been drained.
Always change with fresh water before starting ice production at initial installation or after long shut-off
•
periods.
Dry the interior and exterior with a soft cloth.
•
Please clean your ice maker regularly. When cleaning, unplug the unit and remove the ice cubes. Use
•
a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice maker. Do not
spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse thoroughly before
starting.
• When the machine is not in use, open the drain cap to drain water completely from the water reservoir.
 Space Requirements
During transportation, the incline angle of the cabinet should not be over 45°
•
Do not turn the Ice maker upside down. Problems could occur in the compressor and sealed system.
•
• The Ice maker should be placed horizontally on a properly leveled surface.
To ensure proper ventilation for your Ice maker allow 6" of space at the top, the back and on each side.
•
• Before using the Ice maker for the first time, please wait 2 hours after positioning it.
Clean the inner liner, ice-bin, and water bin.
•
IMPORTANT: Do not install the Ice maker near an oven, radiator, or other heat source.
 Power Failure
Most power failures are corrected within a few hours and should not affect the temperature of your ice
maker if you minimize the number of times the ice-bin is opened. If the power is going to be OFF for a
longer period of time, you need to take the proper steps to disconnect your appliance.
CARE AND MAINTENANCE
ELECTRICAL SCHEMATIC DIAGRAM
11