Publicidad
Idiomas disponibles
Idiomas disponibles
viking range corporation
inStaLLation oF reMote controL SWitcH
Warning: to reduce the risk of burns or ignition
of clothing by reaching across burners, the remote
control must be mounted at least 4" away from any
cook top burner.
keep in mind you do not want to place the control where it
will be in the way for cooking, or where hot pans could be
set, or hot liquids spilled on the control.
. Using the template below, lay out the 3-hole pattern on
the counter top. Mark the centers of the three holes to be
drilled.
2. Carefully drill the three holes through the counter top. Be
careful not to damage or chip the counter top surface when
drilling the holes.
TOP EDGE
1/4" DIA.
HOLE
CUT OUT ON DOTTED LINE
3. Remove the control from the plastic bag. Remove the paper
from the adhesive back of the control, line the control up with
the three holes and position the control so it is parallel with the
front of the counter top. Press down firmly for 60 seconds.
4. Remove the two nylon thumbnuts from the plastic bag and thread
onto the two studs on the control from below the counter top.
Hand tighten only. The thumbnuts just need to be snugged
by hand. They are there to hold the control in place until the
adhesive sets up.
5. Remove cable from the plastic bag and plug into back of con-
trol from below counter top. Route cable through cabinet to
lower right hand corner of downdraft. Plug other end of cable
into the downdraft unit. (Receptacle hole for cabinet is on the
lower right hand side of the downdraft.)
6. Stuff excess cable out of the way and secure the cable so it
is not damaged from items stored in the cabinet.
1/4" DIA.
HOLE
5/8" DIA.
HOLE
9
downdraft Ventilators
Publicidad
