Banner Power Booster PB12 Manual Del Usuario página 10

8. FUSE REPLACEMENT FOR THE BOOSTER
The booster is equipped with an inline fuse, to protect the battery from overload.
Fuse Specification:
Booster 12V:
Fast blow, DC automotive type, rated 32V, 300A (Bussman/Audio Ohm Srl)
Booster 12/24V:
Fast blow, DC automotive type, rated 32V, 500A (Bussman/Audio Ohm Srl)
Keep away from sparks and flame – battery could emit explosive gases.
/!\ WARNING
1. Allow the fuse to cool down completely (approximately 5 minutes).
2. Make sure the switch is in the OFF position and the unit is unplugged from the
external charger.
3. Remove the positive (RED) clamp from the side of the unit and locate the fuse
holder.
4. Open the fuse holder by removing its cover.
5. Using a wrench, remove the first nut and bolt securing the fuse on the positive
cable. Repeat the same steps for the second nut and bolt. Remove the open fuse
and replace it with a new one of the same type and rating.
6. Tighten the nuts and bolts to secure the fuse, and then replace the cover of the
fuse holder.
7. The unit is now ready to use.
9. MAINTENANCE INSTRUCTIONS
9.1.
Cleaning and user maintenance should not be done by children without supervision.
9.2. Unplug the charger from the booster before attempting any maintenance or cleaning.
9.3. Use a dry cloth to wipe all battery corrosion and other dirt or oil from the battery clamps, cords
and the booster case. Do not use cleaning fluids.
9.4. Ensure that all of the booster components are in place and in good working condition.
9.5. All other servicing should be performed by qualified service personnel.
9.6. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons, in order to avoid a hazard.
10. MOVING AND STORAGE INSTRUCTIONS
10.1. Store the booster in an upright position, inside, in a cool, dry place.
10.2. Always make sure the booster is fully charged before storing. When not in use, it is highly
recommended to leave the booster on charge.
Do not use and/or store the booster in or on any area or surface where damage could
IMPORTANT
occur if the internal battery should unexpectedly leak acid.
10