BE FO R E B REW ING
1.
To register your product, go to www.prodprotect.com/blackanddecker
2.
Carefully unpack your coffeemaker, removing all packaging materials, labels, and/or
stickers from your coffeemaker.
3.
Remove the plastic band around the power plug using scissors
4.
Clean your coffeemaker thoroughly before using for the first time. Wash the thermal
carafe and washable brew basket in warm, soapy water. Rinse and dry, then place
back into your coffeemaker.
5.
Clean the inside of your coffeemaker by running two full brewing cycles with water
only, no coffee.
a. Pour fresh, cold water into the water reservoir up to the 12-cup MAX
mark, then place carafe onto the carafe plate.
b. Plug cord into standard electrical outlet.
c. Push the ON-OFF / Power Button to immediately brew water through
the coffeemaker without adding coffee.
d. Once the cycle is finished, discard water.
e. Turn off appliance, unplug and allow to cool down for 15 minutes
before repeating.
PRO GR A M MING YOUR CO FF E E M A KE R
Setting the Digital Clock
1.
Plug the coffeemaker into a standard electrical outlet.
2.
The digital clock display flashes "12:00".
3.
To set the time, press the HR button until the correct hour appears on the
display. The "PM" symbol will appear in the upper right corner of the digital
display for PM time settings.
4.
Press the MIN button to select minutes.
Note: If the unit is unplugged or power interrupted, the time will need to
be reset, as will the Colar Después delay start time.
Setting the Colar Después Delay Start for the first time
The programmable Colar Después delay start allows you to set the 24-hour
timer to brew coffee at the selected time, day or night. To activate the Auto
Brew timer, follow these steps
1.
After the digital clock is set, press the COLAR DESPUÉS button.
The programmed clock time will begin to flash.
2.
COLAR DESPUÉS displays and flashes.
3.
Clock shows last COLAR DESPUÉS time programmed (if no time has been
programmed, or unit has been unplugged, COLAR DESPUÉS time defaults to
12:00)
:
7