Ryobi P306 Manual Del Operador página 5

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of
attachments or accessories not recommended can result
in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Applying hot glue adhesive
WARNING:
Battery tools are always in operating condition. Place
the switch in the off (O) position and remove the battery
pack when the product is not in use or when carrying at
your side.
ASSEMBLY
WARNING:
Do not attempt to modify this product or create accesso-
ries or attachments not recommended for use with this
product. Any such alteration or modification is misuse
and could result in a hazardous condition leading to
possible serious personal injury.
OPERATION
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 8.
 Make sure the on/off switch is in the off (O) position.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's man-
uals for your battery pack and charger.
INSTALLING THE GLUE GUN INTO THE BASE
See Figure 2, page 8
 Make sure the on/off switch is in the off ( O ) position.
 Place the handle of the glue gun into the base.
 Press down to make sure the unit is secure in the base.
INSERTING GLUE STICKS
See Figure 3, page 9.
Use mini 0.28 in. (7.11 mm) or 0.31 in. (7.87 mm) diameter
glue sticks in this glue gun.
 Make sure the on/off switch is in the off ( O ) position.
 Insert a glue stick through the opening at the back of the
glue gun. Guide the glue stick into the glue chamber until
it will go no further.
NOTE: The built in drip tray on the base will catch any
drips while the glue gun is heating.
 Install the battery pack.
 Set the glue gun onto the base and turn the on/off switch
to the on ( I ) position.
WARNING:
To reduce the risk of injury, the glue gun should be
considered to be HOT whenever the LED on the base
is illuminated. Following this rule will reduce the risk of
burns, fire, or serious personal injury.
The LED indicator on the base will light when a charged
battery pack is installed and the switch is turned to the on
5 — English