PURE ELECTRIC Pure Air Go Manual Del Usuario página 20

Maintenance
3.5
Regular maintenance of your Pure Air Go helps keep it safe and
lengthens it's lifetime.
Check all screws before using the e-scooter, especially those
of the handlebar, the hinge, the brakes and the front and rear
wheel. Ensure that all screws are tightened before each ride
as self-tightening nuts and fasteners can loosen over time.
Eliminate any sharp edges caused by use.
A small amount of grease on the inside faces of the clamp
mechanism will help it to release easily each time.
Thoroughly clean the e-scooter with a damp cloth after use. The
front and rear ball bearings should be lubricated from time to
time. Ordinary bicycle oil can be used. Oil the area where the
axles run into the wheels.
Keep both tyres inflated to the maximum pressure as indicated
by the marking on the tyre wall (36psi).
For extra maintenance support, parts or advice, please visit our
of our stores or contact us via the website,
www.pureelectric.com
WARNING!
As with any mechanical component, a vehicle is subject to high
stresses and wear. The various materials and components may
react differently to wear or fatigue. If the expected service life
for a component has been exceeded, it may break suddenly,
therefore risking causing injuries to the user. Cracks, scratches
and discoloration in the areas subject to high stresses indicate
that the component has exceeded its service life and should be
replaced.
Pure Air Go
20