Wibeee Max FLEX 350A Manual De Instrucciones página 20

Before using Wibeee, be sure that the working
conditions are appropriate and that the
protection equipment is adequate.
1. Remove the protection panel
2. Assemble the equipment while paying
attention so that the neutral terminal (N).
2.1. Flexible clips for: L1 (brown),
2.2. Voltage sensors for: N (blue),
2.3. Connect the power supply (yellow)
3. Check that the red LED is on and flashing.
4. Select the scale by briefly pressing RESET.
See section Current sensor for scale selection.
Pages 27 or 29.
5. LED code
Red LED
Blinking
Blue LED, it indicates the connection status
Slow blinking (1s)
Fast blinking (<1s)
Fixed on
20
L2 (black), L3 (gray).
L1 (brown), L2 (black), L3 (gray).
Powered device
No link to a Wi-Fi network
Link to a Wi-Fi network
Sending data over the network
1
N L1 L2 L3
N L1 L2 L3
POWER SUPPLY
N L1 L2 L3 POWER SUPPLY
N L1 L2 L3