Publicidad
Idiomas disponibles
Idiomas disponibles
• Place a "Work in progress" sign near the circuit breaker while the
installation, maintenance, repair or removal work is being carried
out. There is a danger of electric shocks if the circuit breaker is
set to ON by mistake.
• Only a qualifi ed installer (*1) or qualifi ed service person (*1) is
allowed to undertake work at heights using a stand of 50 cm or
more or to remove the intake grille of the indoor unit to undertake
work.
• Wear protective gloves and safety work clothing during
installation, servicing and removal.
• Do not touch the aluminium fi n of the unit. You may injure
yourself if you do so. If the fi n must be touched for some reason,
fi rst put on protective gloves and safety work clothing, and then
proceed.
• Before opening the intake grille, set the circuit breaker to the OFF
position. Failure to set the circuit breaker to the OFF position
may result in injury through contact with the rotation parts. Only a
qualifi ed installer (*1) or qualifi ed service person (*1) is allowed to
remove the intake grille and do the work required.
• When work is performed at heights, use a ladder which complies
with the ISO 14122 standard, and follow the procedure in the
ladder's instructions. Also wear a helmet for use in industry as
protective gear to undertake the work.
• Before cleaning the fi lter or other parts of the outdoor unit, set
the circuit breaker to OFF without fail, and place a "Work in
progress" sign near the circuit breaker before proceeding with
the work.
7-EN
• Before working at heights, put a sign in place so that no-one will
approach the work location, before proceeding with the work.
Parts and other objects may fall from above, possibly injuring
a person below. While carrying out the work, wear a helmet for
protection from falling objects.
• The refrigerant used by this air conditioner is the R410A.
• The air conditioner must be transported in stable condition.
If any part of the product is broken, contact the dealer.
• When the air conditioner must be transported by hand, carry it
by two or more people.
• Do not move or repair any unit by yourself. There is high voltage
inside the unit. You may get electric shock when removing the
cover and main unit.
• To transport the air conditioner, wear shoes with additional
protective toe caps.
• To transport the air conditioner, do not take hold of the bands
around the packing carton. You may injure yourself if the bands
should break.
• This appliance is intended to be used by expert or trained users
in shops, in light industry, or for commercial use by lay persons.
Selection of installation location
• When the air conditioner is installed in a small room, provide
appropriate measures to ensure that the concentration of
refrigerant leakage occur in the room does not exceed the
critical level.
• Do not install in a location where fl ammable gas leaks are
possible. If the gas leak and accumulate around the unit, it may
ignite and cause a fi re.
– 4 –
8-EN
Publicidad
