Publicidad
Idiomas disponibles
Idiomas disponibles
5. OPERATING INSTRUCTIONS
It is recommended that you installed your appliance in a place where the ambient temperature is
between 10-32°C. If the ambient temperature is above or below recommended temperatures, the
performance of the unit may be affected and it may not be possible to obtain temperature between 5-20°C.
Control panel
•
"LIGHT" Button
Lighting control button
•
"POWER" Button
On/Off switch
•
"DISPLAY"
Electronic temperature display
•
"UP" Button
+ Temperature setting button.
•
"DOWN" Button
- Temperature setting button.
•
"°C/°F" Button
- Reverse °C to °F.
•
"Temperature selection" Button
- Button to see the inner temperature – and after 5 seconds go back to show setting temperature .
• You can choose the desired chamber temperature by using the "+ / -". buttons. The temperature
selected increases/decreases by 1°C with each button press.
• The temperature can be chosen between 5 and 20°C. At any time, the inner cellar temperature is visible
by pressing the temperature selection buttons for 5s. The display will flash for about 5s before indicating
the set cellar temperature.
• If the appliance runs after a power failure, the previous set temperature does also exist as the control
panel has the memory function.
When the surrounding temperature is 25°C and the wine cooler has no bottle loaded, it will take
around 30 minutes to increase the wine cooler's temperature from 5°C to 12°C. Under the same
circumstance, it will take around one and half hour to decrease the wine cooler's temperature from
12°C to 5°C. The less the temperature span is, the less time it will take. The setting temperature of
upper zone should be lower than the setting temperature of lower zone
34
Publicidad
