Descargar Imprimir esta página

ASBER EASY-H500 Manual De Instrucciones página 47

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
asberprofessional.com
 
 
 
 
 
 
 
 
6.1.2
Switching on the machine
Before switching on the machine, check the following:
To switch on the machine, turn the selector switch from 0 to STANDBY. (See figure).
 
 
 
 
6.1.2.1 Filling and heating.
When the machine is switched on, it will start to fill. First the rinse boiler is filled and then the wash
tub. The filling process may last a few minutes. Once the wash tub is full, the boiler and the tub start to
heat up. Although it is possible to start the wash process, this is not recommended as the water inside
the machine is not yet at the ideal temperature. When the machine has reached the ideal temperature
for washing the dishes properly, the amber light comes on, advising the user that the machine is
ready.
The required temperature of the machine is 85 ⁰C / 185 ⁰F in the rinse boiler and 60 ⁰C / 140 ⁰F in the
wash tub. ASBER recommends that the water in the dishwasher is changed every 40/50 washes or
twice a day.
 
 
46
asberprofessional.com
 
STANDBY 
55 S CYCLE 
75 S CYCLE 
Figure 9 EASY‐H500 HP control button 
The mains switch must be on.
The water stop cock must be open.
There must be water in the mains network.
The corresponding filters must be in place.
The overflow should be mounted in place.
The hood must be closed for the machine to start filling. For safety 
reasons, if the hood is open, the machine will not fill.
 
MACHINE OFF
CONTINUOUS CY‐
CLE 
120 S CYCLE 
 
ENGLISH
DRAINAGE CYCLE 
(Only in EASY‐H500 B model) 
 

Publicidad

loading

Este manual también es adecuado para:

Easy-h500 hp