Publicidad
Idiomas disponibles
Idiomas disponibles
1. Check work area for:
• Adequate lighting
• Flammable liquids, vapors or dust that
may ignite. If present, do not work in
area until sources have been identified
and corrected. The micro CA-350x In -
spection Camera is not explosion proof
and can cause sparks.
• Clear, level, stable, dry place for opera-
tor. Do not use the inspection camera
while standing in water.
2. Examine the area or space that you will
be inspecting and determine if the micro
CA-350x Inspection Camera is the cor-
rect piece of equipment for the job.
• Determine the access points to the
space. The minimum opening the cam -
era head can fit through is approxi -
mate ly
3
/
" (19 mm) in diameter for the
4
17 mm camera head.
• Determine the distance to the area to
be inspected. Extensions can be add ed
to the camera to reach up to 30' (9 m).
• Determine if there are any obstacles
that would require very tight turns in
the cable. The inspection camera ca -
ble can go down to a 5" (127 mm) ra-
dius without damage.
• Determine if there is any electrical pow -
er supplied to the area to be inspected.
If so, the power to the area must be
turned OFF to reduce the risk of electric
shock. Use appropriate lock out pro-
cedures to prevent the power from
being turned back on during the in-
spection.
• Determine if any liquids will be encoun-
tered during the inspection. The cable
and imager head are waterproof to a
depth of 10' (3 m). Greater depths may
cause leakage into the cable and im-
ager and cause electric shock or dam-
age the equipment. The handheld dis-
play unit is water resistant (IP54) but
should not be submerged in water.
• Determine if any chemicals are pres-
ent, especially in the case of drains. It is
important to understand the specific
safety measures required to work a -
round any chemicals present. Contact
the chemical manufacturer for required
information. Chemicals may damage or
degrade the inspection camera.
• Determine the temperature of the area
and items in the area. See Specifica-
999-995-164.08_Rev. A
micro CA-350x Inspection Camera
tions. Use in areas outside of specifica-
tion temperatures or contact with hotter
or colder items could cause camera
damage.
• Determine if any moving parts are pres-
ent in the area to be inspected. If so,
these parts must be deactivated to pre-
vent movement during inspection to
reduce the risk of entanglement. Use
appropriate lock out procedures to pre-
vent the parts from moving during the
inspection.
If the micro CA-350x Inspection Camera is
not the correct piece of equipment for the job,
other inspection equipment is available from
RIDGID. For a complete listing of RIDGID
products, see the RIDGID catalog, online at
RIDGID.com.
3. Make sure the micro CA-350x Inspec -
tion Camera has been properly inspect ed
before each use.
4. Install the correct accessories for the ap-
plication.
Operating Instructions
WARNING
Always wear eye protection to protect
your eyes against dirt and other foreign
objects.
Follow operating instructions to reduce
the risk of injury from electrical shock,
entanglement and other causes.
1. Make sure that the Inspection Camera
and work area have been properly set
up and that the work area is free of
bystand ers and other distractions.
2. Press and hold the Power Button for two
seconds. The imager lights should come
ON, then a splash screen will appear.
This screen tells you the device is booting
up. Once the product is fully powered up,
the screen will automatically switch to
the live screen.
9
Publicidad
