Publicidad
Idiomas disponibles
Idiomas disponibles
4. Hook the strap hook of the grass collection bag on the
center bar on the lower handle frame (Fig. 12). Adjust the
strap to an appropriate height so that the grass collection
bag does not rub against the ground while mowing or
transporting the unit.
Fig. 12
Strap hook
Locking
strap
5. The mower can be used without the grass collection bag.
When the grass collection bag is not attached, adjust the
ejector flap to a suitable position to shield flying grass
clippings (Fig. 13).
Fig. 13
Operation
This reel mower is intended for private residential use to cut
grass in small lawns and gardens. This reel mower is not
intended to cut grass in public parks, playing fields, farms, or
forests. Do not use this reel mower for any application other
than that for which it is intended.
Adjusting the Cutting Height
This cordless reel mower is equipped with a 4-position height
adjustment system to tailor grass cutting heights from 0.6 inch
to 2.0 inch. To change the cutting height of the grass, follow
the instructions below.
m
WARNING!
Before making these adjustments, remove
the battery and the safety key from the lawn mower and wait
until the rotating blades have come to a complete standstill.
ALWAYS FOLLOW ALL SAFETY PRECAUTIONS AND
RECOMMENDATIONS LISTED PREVIOUSLY IN THIS
MANUAL.
Grass collection bag
Ejector flap
12
1. Power off the reel mower and remove the battery and the
safety key.
2. To adjust the cutting height, pull out the height adjustment
knobs on both sides of the reel mower frame and insert
the knobs to the desired setting (Fig. 14).
Fig. 14
Height adjustment
knob (on both sides)
3. To adjust the reel to the highest cutting position, place the
adjustment knobs through the top hole (position A) located
on the sides of the reel mower frame. To adjust the reel to
the lowest cutting position, place the adjustment knobs
through the bottom hole (position B) located on the sides
of the frame (Fig. 15).
Fig. 15
Highest cutting position
Position A
4. Other cutting heights are achieved by moving the
adjustment knobs to the settings between the highest
and lowest positions. Refer to the mark beside the height
adjustment knobs when adjusting the cutting height
(Fig. 16).
4-Position Height Adjustment:
(1) Low: 0.6 in. (15 mm)
(2) Medium: 1.0 in. (28 mm)
(3) Medium: 1.5 in. (39 mm)
(4) High: 2.0 in. (50 mm)
The cutting height tolerance is +/- 0.12 in. (3 mm).
Lowest cutting position
Position B
Publicidad
