CareOne AHBPS-060 Manual página 9

1. I f the cuff is not assembled, pass the end of the
cuff furthest away from the tubing through the metal
D-ring in order to form a loop. The smooth side
without the felt material should be on the inside of
the cuff loop.
End of cuff
D-ring
2. P lug the cuff tube into the left side of the unit.
Insert plug here
Felt Material
on the outside
of cuff
15
3. O pen the arm cuff so that your arm may be placed
through it.
4. R emove tight fitting clothing from your upper left arm
so that the cuff can be wrapped around
your exposed arm.
5. P osition cuff edge 0.8-1.2
inches (2-3 cm) above elbow.
6. Center tube over middle of arm.
7. P ull the end of the cuff so that it tightens
evenly around your arm. Press the hook
and loop material together to secure.
Allow room for 2 fingers to fit between the
cuff and your arm.
8. L ay your arm on a table (palm upward)
so the cuff is at the same height as your
heart. Make sure the tube is not kinked.
16