Bentel Security BTEL-3G Manual De Instalación página 18

Periodic Message
Send a programming text message by using the following formula:
#Installer PIN#PER#Receiving Number#Message Text#Interval#
where the following are enclosed by # signs:
 Installer PIN; a numeric code of 5 digits (from 00000 to 99999). The factory default installer PIN is 11111.
 PER; the program command to send periodic text messages.
 Recipient Number: type the phone number of the recipient (not its position in the phone book). The telephone
number may also be a number not found in the phone book.
 Message Text ; type the text message to send (maximum 100 characters).
 Periodo; interval at which the message is sent, expressed in days, from 1 to 365 (type 0 to disable and disregard
the Message Text field).
     The periodic message will be sent after the set number of days and always at the time of day at which
it was programmed.
Pay As You Go Balance
     The pre-paid SIM CARD credit management service may be suspended at any time, at the discretion of
each individual GSM network operator.
     Check the operation cost with the SIM CARD operator.
You can check the credit remaining on the pre-paid SIM CARD. If this option is programmed, a text message containing the credit
balance information provided by the operator is sent to a number in the phone book (the number must be in the phone book;
see "Paramaters Management->Phone Book Management "). For this purpose, depending on the type of operator, you
need to send a programming text message in the following format:
#Installer PIN#Request Type#Request Number#Message Text#Interval#
where the following are enclosed by # signs:
 Installer PIN; a numeric code of 5 digits (from 00000 to 99999). The factory default Installer PIN is 11111.
 Request Type; choose the type of request (0=Call, 1=Text message, 2=Network command, 3=Reset).
 Request Number ; the telephone number to call or send a text message to for credit information (for example
414=Vodafone, 40916=TIM).
 Message Text ; (for example PRE CRE SIN).
 Interval; type the Interval (from 1 to 3600 minutes) within which the credit balance information should be received
from the operator in order to be forwarded to the number from which the request was received.
UPDATE THE FIRMWARE
To update the firmware, you will need to connect a PC-Link cable(see Figure 1) from the connector [17] on the BTEL-
3G to one of the COM ports on the PC; the BTEL-3G FW Update application and the update files can be downloaded
from the Bentel website. Make sure you insert the PC-Link cable connector in the right way. Once the connection is made,
choose the COM port that is being used and the update file and click on the Next button: the application will show some
information about the device that is connected. Click on Next to proceed with updating the firmware. Check the serial link
and the serial port settings in case of communication problem, or use a different USB-RS232 adapter.
     To install and run the "BTEL-3G FW Update" application, you will need to log on to the PC as the
Administrator; we also recommend that any anti-virus programs and/or firewalls are disabled if problems
arise while the application is being installed.
18
Operator Example for Italian Operators
TIM
#11111#1#40916#PRE CRE SIN#1#
Vodafone #11111#1#414#CREDITO#1#
Wind #11111#2#*123###1#
BTEL-3G