HAIRCUT PROFESSIONAL TH36 Manual De Utilización página 23

EN
PROFESSIONAL CORDLESS CLIPPERS
3.4. Using the comb attachments
 The clippers
(Fig. 1 refs. E-J).

Place the comb attachment on the blades and clip in at the rear. When the comb
attachment is correctly fixed, it is immobilized.
3.5. Replacing blades
 Switch the clippers off and unplug the unit from the mains power supply.
 Take the screws out of the blades (Fig. 4) and remove the upper and lower
cutters.
During their assembly, the upper and lower cutters must be aligned as instructed
below:
 Set the adjusting lever to the minimum cutting height.
 The distance between the front edge of the lower cutter and the front edge of
the upper cutter must be between 0.8 mm and 1.5 mm.
 The upper and lower cutters must be set parallel.
 The end tooth on the upper cutter (on the left-hand end) must cover the end
tooth on the lower cutter.
 The other end tooth on the upper cutter (on the right-hand end) must also touch
the corresponding end tooth on the lower cutter (on the right-hand end).
 Tighten the two screws (Fig. 4).
must be switched off. Select
23
a comb attachment