Publicidad
Idiomas disponibles
Idiomas disponibles
Read the following switch usage instructions for lighting and
to extinguish:
OPEN
Step 1: Lighting
Open the igniter button and install an AAA
battery (not included), then secure the cap
back on. Before usage, make sure that the
control knob is in the "OFF" position. Turn the LP
cylinder gas valve to fully open position. Press
down on the control knob and turn counter
clockwise to the "LOW" position. Push in the gas
control knob all the way and hold, continue to
press the ignition button for 15 seconds.
Note: To extinguish the flame, push the control knob in and rotate clockwise.
CARE AND MAINTENANCE:
1. Do not use aerosol polish or any other flammable
material to clean the burner while it is in use.
2. Inspect and clean the burner regularly. Use a
wire-bristle brush to clean the burner surface.
A straightened paper clip is useful to remove debris
or rust from the small burner ports.
3. Wash frame parts with mild soap and water, rinse
thoroughly, and dry completely. Do not use bleach,
acid, or any other solvents on the frame parts.
4. Inspect and tighten all of the bolts and fasteners on a
regular basis to ensure the proper performance and
safety of your appliance.
5. When not in use, we recommend that it be stored in a
dry and secure area. Always disconnect the LP gas
tank first and store it safely outside.
6. The minimum clearance from the sides, rear, and top of
unit to adjacent combustible construction: 2' (61 cm)
from the sides, 2' (61 cm) from the rear, and 5' (152.5 cm)
from the top.
7. Improper lighting operations will cause serious injury
and explosion.
V-3
Switch Usage Instruction
AAA
OFF
LOW
CLOSE
HI
DO NOT RETURN TO THE STORE!
STOP
OFF
ON
Step 2: Adjusting and Shutting Down
If the burner is not lit, press down the control
knob and turn clockwise to the "OFF" position.
Repeat step 1 after 5 minutes. When the burner
is lit, press down the control knob and turn it to
desired heat output position between "LOW"
and "HI". Press down and turn the control knob
clockwise to the "OFF" position to shut down
the appliance. Turn off cylinder gas value.
TYPES OF GAS
Min.Gas supply for input Adj. 25 psi
Maximum Inlet Pressure
Manifold Pressure
Gas Rating
Caution:
The gas pressure regulator provided with this appliance
must be used. This regulator is set for an outlet pressure of
11 inches water column.
PAGE 7 OF 9
OFF
OFF
LOW
ON
HI
PROPANE GAS
250 psi
11 in.w.c
46,000 Btu/hr
Publicidad
