Oursson EK1716P Manual De Instrucciones página 9

The kettle is equipped with protection from
switch-on without water. If you turn on the kettle
with no water or less then MIN mark, the device
will turn off after a few seconds. After cooling
the heating element, the kettle will get back to
working condition. Clicking sounds made by the
kettle, indicate the reset of thermostat.
To accelerate the cooling of the heating
element, do not fill kettle with cold water. This
may damage the heating element.
Before firsT use:
• Wash the inner surface of your new kettle with the use
of non-abrasive cleaners. Dry the kettle. Wipe the kettle
with a clean dry cloth.
• Boil the maximum amount of water in a safe manner as
described in the previous section. Monitor for no leaks,
sparks, melting of body, stand, excessive heating of
the power cord, plug, and burning smell during first two
boiling.
• Boiled water from the first two boiling is not recom-
mended to use in food. You can use it for everyday
needs.
oPerATion orDer:
Boiling the water:
1. Remove the kettle from the base, open the lid (Pic. C-2),
and fill it with water.
ProDucT cerTificATion
For information on product certification, see http://www.oursson.com or ask seller for a copy.
specifications
Model
Power consumption, W
Rated voltage
Level of protection
Storage and transportation temperature
Operating temperature
Humidity requirements
Dimensions, mm
Weight, kg
Capacity, L
*
Products should be stored in dry, ventilated warehouses at temperatures below
Reparation must be performed only by a qualified personnel authorized by OURSSON AG service
center.
SERVICING
Company OURSSON AG expresses great appreciation to
you for choosing our products. We have done everything
possible so that this meets your needs, and the quality
corresponds to the best world standards. If your OURSSON
branded product will need maintenance, please contact one
of the authorized service center (hereinafter - ASC). A com-
plete list of ASC and their exact addresses can be found on
the website www.oursson.com.
2. Close the lid and put the kettle on the base. Plug it in.
3. Push button down. Water will heat up.
After boiling the water, the kettle will automatically turn off.
Turning off the kettle
There are two ways of turning off the kettle:
• Push button up, when the device is working;
• When the kettle is working, remove it from the stand.
note: The thermometer will not show the temperature if
there is no water in the kettle or its level is lower than the
minimum.
cLeAning AnD mAinTenAnce, Рiс. D
Hard water can leave scale in the kettle. Use special
cleaners for descaling. Follow the instructions of the used
detergent. Do not use abrasive or harsh cleaners.
• Fill the kettle halfway with water.
• For every 2 cups of water, add 6 tablespoons of white
vinegar 8%.
• Bring to a boil.
• Repeat the procedure if necessary.
• Unplug it.
• Allow the kettle to cool and rinse it twice with cold water.
• Wipe the outside of the kettle with a clean, soft,
damp cloth. In order to prevent electrical shock do
not immerse the entire product or the wires into
the water.
• Thoroughly dry all the parts of the device.
While utilizing the kettle, the heating element
can change the color, but that will not affect
the kettle's work.
EK1716P
max 2200
220-240V~; 50-60 Hz
I
from -25°C to +35°C
from +5°C to +35°C
15-75%
219x156x251
0,9
1,7
Warranty obligations OURSSON AG:
1. Warranty obligations OURSSON AG, provided ASC
OURSSON AG, apply only to models designed
OURSSON AG for the production or supply and sale wi-
thin the country where the warranty service is provided,
purchased in this country, certified for compliance with
the standards of this country, and also marked the with
official marks of conformity.
2. Warranty obligations OURSSON AG operate within the
- 25°С.
9