Publicidad
Idiomas disponibles
Idiomas disponibles
Wheat,
2
10-80 g
Rye
Cinnamon
2
5-25 g
sticks
Chilli
1
5-25 g
peppers
Sea salt
2
10-80 g
Pepper
2
10-80 g
Parsley
1
10-20 g
Sugar
2
10-80 g
cubes
Garlic
1
20-40 g
Ginger
2
10-80g
• Please note that the ground product may become
slightly sticky depending on the oil content of the nuts.
• You can also use the 4-wing stainless steel container
for pesto, dressing or spice mixes.
• Smaller quantities of coffee beans and nuts can also
be ground on level 2 (higher speed), while larger
quantities stick together more easily and become
hotter at higher speed. Therefore, we recommend
using level 1.
Cleaning
• Unplug the appliance before any cleaning.
• Clean the coffee bean vessel after every use.
• Clean the outer surface and the vessel with a dump
cloth and the lid with a dry cloth.
ATENTTION: use it just on the outer
surface! Do not use these cleaning
agents in surfaces that come into
contact with food (inner surface).
• Clean regularly the thread in the appliance and the
lid. If this thread is dirty or covered by coffee the sa-
fety lock will not work and the appliance will not be
able to function.
• Never rinse the vessel with water.
• Do not use abrasive cleaning agents, sprays or scou-
ring sponges.
• Treat the appliance with special cleaning agents for
stainless steel to eliminate small impurities (like fin-
gerprints).
2 bladad-
20-40 s
cutter
2 bladad-
30s
cutter
2 bladad-
20-30 s
cutter
2 bladad-
5-10 s
cutter
Spare Parts
Hood = ART-741-SP01
2 bladad-
5-20 s
Lid = ART-741-SP02
cutter
Stainless steel container with 2-bladed cutter
4 bladad-
= ART-741-SP03
5-20 s
cutter
Stainless steel container with 4-bladed cutter
= ART-741-SP04
2 bladad-
10-20
cutter
Impulses
Problem / cause / remedy
4 bladad-
2
cutter
Impulses
4 bladad-
2-5 s
cutter
NOTE
Highly aromatic foods such as coffee can cause the
container to take on this aroma / taste. This is normal
and not a reason for complaint. We therefore recom-
mend that you purchase an additional container -
this can be obtained from our service department.
Problem
cause
The device
The device is
does not
not connected
function
The cover was
not attached
properly
Ingredients
Application too
are excessively
short
coarse when
ground
Excessive
quantity
Wrong stainless
steel container
used
Product sticks
Speed too high
to the edge of
the container
when ground
Running time
too long
EN
remedy
Plug the plug
into the socket
The cover
must be
locked in an
anti-clockwi-
se direction
Start the pro-
cess again
Use a smaller
amount
Use the
other one
Use a lower
speed setting
Grinding in
pulse mode
11
Publicidad
