Craftmade BW116-HW Guia De Instalacion página 5

4. Installation of Wall Bracket. (cont.)
First determine the approximate position of
where you want the fan to be located on
the wall. [Remember that the fan must be
mounted at least 7 feet (2.13m) from the
floor.]
NOTE: Ensure there is an electrical source
near the approximate location, such as an
existing outlet box or an electrical outlet, as
you will need to pull the supply wires
through the opening in the middle of the
wall bracket.
You MUST use ALL FOUR holes in wall
bracket when installing wall bracket.
Position wall bracket on wood stud or
wood post and mark 4 hole locations.
Drill 4 pilot holes over holes marked onto
mounting surface. Position wall bracket
over pilot holes and install screws (provided
in hardware pack) into each hole.
ALTERNATE CONCRETE WALL
INSTALLATION: Use all 4 mounting 1/4"
(6.5mm) holes when installing wall bracket
on a concrete wall. The 3/16 in. (5mm)
concrete wall anchors necessary for this type
of installation are NOT provided and must be
purchased separately. Make sure that
concrete wall anchors can support a total
of 80 lbs.
WARNING: It is very important you use the
proper hardware when installing the wall
bracket as this will support the fan.
1/4"
pilot holes
(6.5mm)
mounting
hole
screws
screws
page 5
stud
stud
wall
bracket
7 feet
(2.13m)