Craftmade BW116-HW Guia De Instalacion página 6

5. Wiring.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code (or the Canadian Electric Code). If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to below, please use a qualified electrician.
NOTE: There must be four house wires for proper
installation and operation of the fan. If a fourth
wire is not present, please obtain the services of
a qualified electrician to have the wire installed.
Attach wires from 4-wire plug (and wall bracket)
to the supply wires (from the wall) as follows:
Connect GREEN (GROUND) wires (from 4-wire
plug and wall bracket) to GREEN/BARE wire from
wall with wire connector provided.
Connect BLACK wire from 4-wire plug to BLACK
wire from wall with wire connector provided.
Connect WHITE wire from 4-wire plug to WHITE
wire from wall with wire connector provided.
Connect BLUE wire from 4-wire plug to RED wire
from wall with wire connector provided.
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch. Wire the WALL CONTROL
with wire connectors provided as shown in
diagram at right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
WARNING: CONNECT WIRES IN THE
FOLLOWING ORDER ONLY!
Connect GREEN ground wire to ground from
house or directly to one of the screws from the
outlet box.
Connect BLACK/WHITE wire from wall control to
BLACK (hot) lead wire from house.
Connect BLACK wire from wall control to BLACK
load wire to fan.
Connect BLUE wire from wall control to BLUE
load wire to fan.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front
plate to wall control using 2 screws provided in
the wall control.
connector
WHITE
4-wire
plug
BLACK
GREEN
Modifications not approved by the party responsible for compliance
could void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
outlet box
GREEN/BARE GROUND
BLACK
BLACK
(AC IN L from
breaker box)
BLUE
(blue load from fan)
page 6
wire
WHITE
BLUE RED
BLACK
GREEN
GREEN
wall control
GREEN
BLACK (to motor)
BLACK w/ WHITE
STRIPE (AC IN L)
BLUE
(fan rotation)
black with
white stripe
(AC IN L)
wall
bracket
plate