1byone 436UK-0005 Manual De Instrucciones página 5

Rear View
EN
DE
FR
ES
IT
1. RCA Input
2. Speaker Output
3. AUX Input
4. Power Cord
Note: The regulatory logos vary amongst different countries to conform with standards in different regions and countries.
4
Side Control Panel
1. Power Switch:
• Please note that plugging into power and pressing the Power switch to "On" will put the
Standby/Source
speaker into standby mode and turn the LED red.
• To play audio, press the remote's Power button or press and hold the speaker's Volume dial to
Volume
turn off standby mode.
2. Standby/Source/Volume Dial:
• Press in and hold the Volume dial for 2 seconds to turn off standby mode and allow for audio
Treble
playback. The remote control's Power button may also be pressed to turn off standby mode.
• Quick press the Volume dial to switch between audio sources, with each source represented
with a different LED pattern and color - Solid green LED for RCA input, flashing green LED for
Bass
5 AUX input, and flashing blue LED for Bluetooth. Audio sources can also be switched using
the remote control.
POWER
• While in standby mode, the speaker system will remember the source and settings previously
ON
selected and use this same source when the speaker is next taken off standby mode. These
OFF settings will be erased if the speaker is switched off or is disconnected from power.
• Rotate to dial to adjust volume level. When connecting to a new source and audio device,
always start with a low speaker volume level and slowly increase volume until the preferred
volume level is reached.
3. Treble Dial
4. Bass Dial
5. Headphone Jack
5
EN
DE
FR
ES
IT