Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION WALL KIT
The air outlet hose must be used in the "cool" or "auto" mode.
During the "fan", "heat" or "dry" mode, you don't need to attach
the air outlet hose.
1.
Make an opening in the wall the size of the wall adapter (125
mm).
Insert the wall adapter into the opening and attach it to the
wall using the 4 supplied plugs and screws.
2.
Place the hose/appliance connector on one side of the air
outlet hose and the hose/wall adapter connector on the other
side of the hose. The connectors snap into place as soon as
you push them onto the hose.
3.
Attach the hose to the unit. The side of the hose with hose/
appliance connector must be mounted on the air outlet at
the back of the appliance. Slide the connector into the air
outlet holders. Make sure that the hook on the connector
matches the notch above the air outlet.
4.
Attach the air outlet hose to the wall adapter.
5.
When you are not using the air conditioner, you can close the
wall adapter off using the cover.
USE
CONTROL PANEL
7
1. ON/OFF touch
To turn the unit of or on.
2. SLEEP touch
You can use this touch for activating the "sleep"mode.
When you select this setting, the set temperature will change by 1°C within 30 minutes (increase in the
'cool' setting, decrease in the 'heat' setting). After another 30 min., the temperature will change by 1°C
again. The air conditioning will maintain this temperature for 7 hours. After this time, the air conditioning
will go back to the original set temperature and the "sleep" function will end.
NOTE : this function cannot be selected with the "fan" or "dry" function.
54
DO361A
6
5
1.
2.
3.
8 9
10
4
max 120cm
min 30cm
3
2
max 120cm
min 30cm
or
50cm
1
Publicidad
