Publicidad
Idiomas disponibles
Idiomas disponibles
ATIS
This function is the Automatic Transmitter Identification Sys-
tem. The Atis signal shall be transmitted at the end of each
transmission. The ATIS ID is composed by number of 10 dig-
its, and it is already registered to your radio. The first digit is
pre-selected to "9", but it doesn't appear on the display. From
nd
2
to last digits are displayed. If it's necessary to change the
ATIS or program the private channel, the user should send
back to distributor for reprogramming.
ATIS Verification
1. Push and hold MEM for 1.5 sec-
onds, the radio will change to ATIS
confirmation mode. "ALERT" and 1st
digit start to blink.
Note: If ATIS is not programmed yet, the radio is not able to
change to ATIS confirmation mode.
2. Push MEM to check next digit.
3. Repeat step 2 to 9th digit.
4. Push and hold MEM for 1.5 sec-
onds to exit the verification mode.
Note: Push SCAN to return to step 1
(for checking to once more). Push 16/9 to exit verification mode
and change to EMG 16CH mode.
UIC (for the authorized country only)
This feature can change the following 3 modes of operation;
USA, INT ans CAN. This feature is enabled when user is push-
ing and holding LOCK and 16/9 keys and turns on the radio.
"INT" appears on the display. Push and hold TRI key to UIC
change.
55
Publicidad
