Descargar Imprimir esta página

Domo DO932SBS Manual De Instrucciones página 42

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 46
Shelving and rack adjustment
Shelving and rack adjustment
Important note: all food and drink should be removed from all shelves
and racks before adjusting or removing them
the "UNLOCK" button (child safety lock) for 3 seconds to unblock the panel. The lock will
Important note: all food and drink should be removed from all shelves
disappear on the display.
and racks before adjusting or removing them
You can adjust the shelving in the fridge compartment to your required
configuration. To remove a shelf, lift it up slightly so the plastic stabilisers
You can adjust the shelving in the fridge compartment to your required
that on either side of the shelf are above the shelf rails and then pull it
MOVING THE SHELVES AND DOOR RACK
configuration. To remove a shelf, lift it up slightly so the plastic stabilisers
towards you.
· Empty the fridge before moving the shelves or the door racks.
that on either side of the shelf are above the shelf rails and then pull it
· To move a shelf, raise it and pull it towards you.
towards you.
You can adjust the racks in the fridge and freezer compartments to your
required configuration. To remove a rack hold both sides of the rack, lift
it upwards (1) and then pull it towards you (2).
You can adjust the racks in the fridge and freezer compartments to your
· To move a door rack, grip it firmly with 2 hands. Raise the door rack and pull it towards you.
required configuration. To remove a rack hold both sides of the rack, lift
it upwards (1) and then pull it towards you (2).
LIGHTING
The lighting in the fridge is LED light. This is more ecological and manufactured for a long life.
For this reason, these may not be replaced. If there is a problem with the lighting, contact a
qualified service centre in your area.
MOVING YOUR APPLIANCE
If the appliance is turned off for any reason, wait for 10 minutes before turning it back on. This
will allow the refrigeration system pressures to equalise before restarting.
· Turn off the appliance and unplug it from the mains socket. Remove all food. Also remove
all mobile parts (shelves, accessories, etc.) or fix them into the fridge to avoid any shock.
· Relocate and install. If the appliance has been left on its side for any length of time, leave it
standing upright for at least 10 minutes before turning on.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally
friendly and natural gas, it is explosive. Therefore you should be careful during shipment and
installation to prevent your appliance's cooler elements from being damaged. In the event of
a leak caused by damage to the cooler elements, move your fridge from open flame or heat
sources and ventilate the room where the appliance is located for a few minutes.
42
DO932SBS
1
1
2
2

Publicidad

loading