Truper SOT-250AL Instructivo página 19

Installation
Connections
CAUTION
To prevent electric shock it is necessary
to see information and diagrams in the "Power
Requirements" section in page 3.
• Connect the welding machine to ground (A) as indicated
in page 3.
• Connect the electrode holder to the corresponding bolt
(B) in the welding machine.
• Hold the electrode suitable to the job (C) with the
electrode holder.
• Connect the connection to the work piece to the
corresponding bolt (D) in the welder machine.
• Connect the other end to the table or work piece (E).
• Connect the welding machine to the power source (F) as
shown in page 3.
• If the connectors are not tightened
CAUTION
properly, the internal connection dashboard and the
welding cable may get burned. Double-check all the
connections before starting the welding machine.
C
E
For best results use original parts such as:
- Electrodes (E6013-3, E6013-4, E7018-4, E6011-4)
Truper brand
®
- Cables with ground clamp set (CAB-300P)
Pretul brand
®
F
A
B
D
7
ENGLISH