Publicidad
Idiomas disponibles
Idiomas disponibles
The device must be installed in an absolutely horizontal position.
Always install the device via all fixation holes.
Do only use appropriate screws and make sure that the screws are properly connected with the ground.
Before taking into operation for the first time, the installation has to be approved by an expert!
OPERATION
After you connected the effect to the mains, the EUROLITE LED WMB-18 RGB bar starts running.
Stand Alone operation
1. Chaser
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. With
LED WMB-18 RGB, you can select up to 9 different chasers with up to 500 steps.
Selecting a chaser
Press the MODE button. Select the desired chaser (che1-che8) via the UP or DOWN buttons
(che9 is sound controlled).
Select the desired chaser value via the F/S buttons. (Step Time or Fade Time)
For example: You choose che1 via the MODE button and then press the F/S button to select the desired
Step Time or Fade Time value.
Fade Time from 0 to 100%.
Step Time value from 1 to 500 times/minute.
The desired values can be selected via the UP or DOWN buttons.
Manual Color Mixing
Select the MODE button. Select the F/S button to begin. Use the UP and DOWN buttons to
mix RGB values.
2. Music Controlled Operation
Select che9 and adjust the audio input level using the sensitivity control dial on the side panel of the
controller.
DMX-controlled operation
You can control the devices individually via your DMX-controller.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED WMB-18 RGB bar will respond to the controller.
For address setting, press the Up/Down-buttons until the display shows "A001" and set the desired address
via the Up/Down-buttons.
DANGER TO LIFE!
18/39
51930350_V_1_1.DOC
Publicidad
