EuroLite LED WMB-18 RGB Bar Manual Del Usuario página 19

Controlling:
After having addressed the LED WMB-18 RGB bar, you may now start operating it via your lighting
controller.
Note:
After switching on, the LED WMB-18 RGB bar will automatically detect whether DMX 512 data is received or
not. If the data is received, the control LED flashes. If there is no data received at the DMX-input, the control
LED lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the LED
WMB-18 RGB bar.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol
L I
Control channel 1 – Each spot occupies 6 channels. Eight spots occupy 48 channels.
L2
Control channel 2 – Every 2 spots occupy 6 channels. Eight spots occupy 24 channels.
L4
Control channel 3 – Spots 1-4 and 5-8 occupy 6 channels. Eight spots occupy 12
channels.
L8
Control channel 4 – Each spot occupies the same 6 channels as every other. Eight spots
occupy 6 channels.
19/39 51930350_V_1_1.DOC