Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
The CV-H5-DS is a hand-held desoldering tool which utilizes shop air to create a powerful
Venturi vacuum to clean through-holes quickly and efficiently. Paper solder collection liners
within the hand-piece barrel are easy to maintain and are an improvement upon traditional
glass tubes. Shop air is required for operation.
ACCESSORIES & SPARES
CV-DCF1
CV-DCF1L
CV-DCF1F
CV-DAR1
AC-TC-P
AC-CB1-P
AC-CB2-P
CV-DVC-1
CV-DSL1
CV-DSL2
CV-DSB
CV-DLA
CV-DMK1
CHOOSING THE CORRECT
GEOMETRY
Select a tip with an inside diameter
larger than the lead diameter. Select a
tip with an outside diameter that is
approximately the same size as the
pad.
A standard STDC cartridge can
desolder a maximum lead length of
0.0170." For fast, safe removal of
devices that are difficult to reach on
densely populated boards, or to remove long pin connectors, try the STDC long reach
cartridges. They are identical to standard STDC tip cartridges, but with a 0.46" long extension
at the tip.
CHOOSING THE CORRECT TEMPERATURE (SERIES)
Inside
Outside
Dia.
Dia.
(A)
(B)
0.025"
0.055"
0.030"
0.066"
0.040"
0.070"
0.050"
0.080"
0.060"
0.090"
0.095"
0.125"
** When using long reach cartridges, 600 series heat delivery is insufficient for fast, safe device
removal. Therefore, long reach desolder tips are only available in 700, 800, and 900 Series.
CV-H5-DS Filter Pack; 15 Chamber Liners, 6 Fume Filters
CV-H5-DS Chamber Liners (pack of 40)
CV-H5-DS Fume Filters (pack of 20)
Air Regulator and Filter with Fittings
Desolder tip Cleaner (Pack of 12)
Desolder Chamber Cleaning Brush (Pack of 25)
Desolder Tube Cleaning Brush (Pack of 6)
Venturi Cartridge for Desolder Gun
CV-H5-DS Chamber Seal
CV-H5-DS Cartridge Seal
Desolder Gun Swivel Bushing
Desolder Gun Latch Adjustment (Pack of 10)
CV-H5-DS Maintenance Kit
Correct
Start with a 600 Series cartridge, switching to a
700 Series only where absolutely necessary; for
example, when working with ground planes or
multi-layer boards. For long reach tips, start with
a 700 Series cartridge.
For extremely heavy loads tied to ground planes,
or very thick multi-layer boards, 800 or 900 series
cartridges may be necessary.
600=6
700=7
x=SERIES
DSC-xCN0006S
DSC-xCN0008S
DSC-xCN0010S
DSC-xCN0013S
DSC-xCN0015S
DSC-xCN0024S
2
Too Small
Part Number
800=8
N/A
N/A
N/A
Too Large
900=9
Reach*
N/A
DSC-xCN0008A
DSC-xCN0010A
DSC-xCN0013A
N/A
N/A
Publicidad
