Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
Take the unit out of its box and make
sure that all of the pieces are there
Fig.1.
(1) Main body; (8) Handlebar stem; (22)
Saddle
post;
Handlebar; (24) Monitor; (3) Rear
stabiliser bar; (2) Front stabiliser bar; a
box containing the following: (4) Slot
head bolts M-10; (5) Curved washer M-
10; (6) Cap nut M-10; (13) Curved
washer M-8; (14) Allen screw; (16)
handlebar bracket, (17) screw M8; (18)
Bracket cover; (19) Handlebar lever;
(20) Flat washer M-8; (21) Saddle post
knob; (36) Allen key; (37) Double ended
ring spanner; (38) Pedal spanner; (28)
Left pedal; (29) Right pedal.
FITTING THE STABILISER BARS
Take the rear stabiliser bar (3) and
position it on the machine's rear stand
bracket, as shown in Fig.2, inserts bolts
(4), fit the curved washers (5) the cap
nuts (6) and tighten securely.
Take the front stabiliser bar with wheels
(2) and position it so that the two red
dots (A) line up, as shown in Fig.2,
insert bolts (4), fit the curved washers
(5) the cap nuts (6), and tighten
securely.
FITTING THE HANDLEBAR
STEM
Hold the handlebar stem (8) and
connect the feedback cable terminals
(9) and (10), Fig.3. Take the tension
cable (11) from the handlebar stem (8)
and connect it to the bottom tension
support (12), as shown in Fig.3.
Insert the handlebar stem (8) onto the
boss on the main body (1) in the
direction of the arrow, making sure not
to catch any of the cables, and check
(23)
Saddle;
that the tension control (100) works
correctly. Next, line up the handlebar
stem with the holes and fit the 3 Allen
screws (14) and the curved washers
(13), tighten securely.
(15)
FITTING THE HANDLEBAR
Bring the handlebar (15) up to the
handlebar stem (8), Fig.4, insert the
hand-grip cable (26) in through the slot
as shown in Fig.4, and pull it out through
the top of the handlebar stem. Fit the
handlebar bracket (16), insert screw
(17) and hand tighten, put the washer
(20) on and the handlebar lever (19),
position the handlebar and tighten
gently, then fit the bracket cover (18).
ATTACHING THE SADDLE
Place the saddle (23) onto the saddle
post (22), as shown in Fig.5, bearing in
mind that the holes on the saddle post
go at the front section of the saddle,
position the saddle correctly and tighten
nuts (24) securely. Now insert the
saddle post into the hole on the main
body (1), fit the saddle post knob (21)
and adjust the height of the saddle and
tighten it into position by turning the
saddle post knob (21) clockwise.
ADJUSTING THE SADDLE HEIGHT
Loosen the saddle post knob (21) a
little, turning it anticlockwise, and pull it
back, Fig.5, adjust the height of the
saddle to suit the exercise and then
release the knob so that it slots back
into one of the holes on the saddle post.
Tighten the knob (21) securely by
turning it clockwise.
FITTING THE MONITOR
Remove the screws (25) from the back
of the monitor, then place the monitor
on top of the main post in the direction
9
Publicidad
