Bimar HP120 Manual De Instrucciones página 11

• Ensure the heating element is free of dust, lint, or any similar material: this
improves the fan heater's performance, and prevents overheating.
Periodically check that the aspiration grille does not become obstructed by
objects, fabrics or other materials to prevent overheating or breaking the
appliance.
INSTALLATION
• After unpacking, check that all parts of the appliance are present; if in doubt, do not use and
contact a qualified technician. The packaging materials (plastic bags, polystyrene, metal staples,
etc.) must not be left within reach of children, as they are potentially hazardous.
• Before connecting the appliance, check that the voltage on the data plate matches that of the
electric system. In the event of incompatibility between the plug point and the appliance's plug,
have the plug replaced with a suitable model by a qualified professional, who should ensure that
the cord is suitable for the power rating of the appliance (10A). Check that other appliances with
high absorption are not connected to the power line to avoid overloading and fire hazards. The use
of adaptors or extensions is generally not advisable; if it is necessary to use them, they must
comply with safety regulations and the total current (amps) must not be rated lower than the
maximum current of the appliance.
• Before each use, check that the appliance is in good condition and that the power cord is not
damaged: if in doubt consult a qualified professional.
• Ensure that the power cord is correctly positioned and does not come into contact with hot parts or
sharp edges, or become wound around the appliance itself and is not twisted.
• Do not hang or even lean the appliance against any walls.
• Place the fan heater far from any other source of heat, from flammable material (curtains,
tapestries, etc.), from flammable gases or explosive objects (spray cans) and from materials that
can be deformed by heat. Make sure there is 120 cm of free space in front of the fan heater and
50cm free space on both sides and behind it.
• The surface where the appliance is used must be stable, spacious (do not use on shelves), level
(since the appliance could tip over) and heat resistant.
USING THE APPLIANCE
First use: run the appliance to eliminate the "new smell" and any oil residue from the manufacturing
process for at least 10/15 minutes. During this operation, ventilate the room well to eliminate the
"new smell" that is given off by the appliance.
The heating fan can be adjusted using the following:
-Selector. By turning the relative knob clockwise, you can select these functions:
only ventilation,
-Room thermostat. It adjusts the appliance's functions according to the temperature, continuously
until reaching the set temperature, then at intervals to keep it constant. By turning the relative knob
completely anti-clockwise the heating fan remains off (pos."-"), when turned completely clockwise it
is set on the maximum temperature (pos."+"), in intermediate positions the surrounding temperature
is lower.
- Indicator light: comes on according to the thermostat's operation. It is on when the appliance is
running.
- Right-left oscillation: press the oscillation button (
left, pos. "I", press again the button in pos "•" to off.
= hot air (1000W) = very hot air (2000 W).
), to allow the appliance to swing from right to
11
0= off,