First Use; Charge Of The Battery; Fitting The Video Cam - EYENIMAL Dog Videocam Manual De Instrucciones

● First use
It is necessary to fully charge the battery of your video cam before the first
use (duration of the 1
● Charge of the battery
To charge your product, the video cam must be necessarily turned off.
To charge your product, proceed in the following way:
 Unscrew the metal cap to the rear of the video cam.
Diagram 1
USB port to charge
the battery
 Plug the line cord to the receptacle at the bottom of the video cam.
 Then plug the line cord of the computer.
 When the battery is charging, the indicator light turns red (the charge of the
product takes approximately two and half hours).
 Once the battery is fully charged, the red indicator light goes out to indicate that your
product is completely recharged.
 Disconnect the video cam from the line cord.
 Disconnect the line cord from the computer.
 Screw the metal cap to the rear of the video cam back on.
● Fitting the video cam
1/ Fit the video cam on its mount
Proceed as follows to fit the video cam on its mount:
 Open the video cam mount clamp.
 Position the video cam in the clamp.
 Close the clamp.
Fitting the video cam in the clamp
st
charge: 8 hours).
Diagram 2
17