OPERATION
R8611506 HAMMER DRILL / R86039 IMPACT DRIVER
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the product when
you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery
pack will prevent accidental starting that could
cause serious personal injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING:
Battery tools are always in operating condition.
Lock the switch when not in use or carrying at your
side, when installing or removing the battery pack,
and when installing or removing bits.
NOTICE:
To prevent gear damage, always allow the tool
to come to a complete stop before changing the
direction of rotation.
HIGH TEMPERATURE PROTECTION
Li-ion battery packs are equipped with a high temperature
protection feature that automatically deactivates the tool
when it is overheated. To resume operation, allow the tool
to cool and then squeeze the trigger.
OVERLOAD PROTECTION
When the tool is forced or the motor is overloaded, the tool
will automatically shut off. To reset the tool, release the trigger
and resume operation. If the tool still does not resume opera-
tion, remove and reinsert the battery. Do not force the tool.
RECOMMENDED BATTERY PACKS
OCTANE
tools are compatible with all RIDGID
™
battery packs, but tool performance is maximized with
OCTANE
battery packs.
™
If you experience frequent shutoffs due to overload
protection, try using an OCTANE
18 Volt
®
battery pack.
™
7 - English
APPLICATIONS
You may use this product for the purposes listed below:
R8611506
Drilling and driving screws in all types of wood products
(lumber, plywood, paneling, composition board, and hard
board), ceramics, plastics, fiberglass, laminates, metals;
Driving screws into wood and drywall with screwdriver bits
R86039
Driving and removing screws/lag bolts; tightening screws,
nuts, and bolts
INSTALLING/REMOVING BELT HOOK
See Figure 3, page 13 (R8611506).
See Figure 1, page 14 (R86039).
The belt hook may be installed on either side of the housing.
Align hole in belt hook with hole in tool's base.
Install screw to secure belt hook in place.
To uninstall, remove screw and then belt hook.
INSTALLING/REMOVING BATTERY PACK
See Figure 4, page 13 (R8611506).
See Figure 2, page 15 (R86039).
Lock the switch trigger.
Insert the battery pack into the tool.
Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured in the
product before beginning operation.
Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's
manuals for your battery pack and charger.
VARIABLE SPEED SWITCH TRIGGER
See Figure 5, page 13 (R8611506).
See Figure 3, page 15 (R86039).
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the chuck to come
to a complete stop.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
NOTE: Operating at low speeds under constant usage
may cause the tool to become overheated. If this occurs,
cool the tool by running it without a load and at full speed.
The electric brake will stop the bit rotation after the operator
releases the switch trigger.