Axxess AX-ADCH01 Instrucciones De Instalación página 5

Attention! The AX-ADCH01 will work with both the AX-ADBOX1 and AX-ADBOX2 interfaces,
but programming will be different. Refer to the proper page for whichever interface is being
used. Also note, the programming instructions for the AX-ADBOX2 reflect gen. 2. If installing a
gen. 1 AX-ADBOX2, refer to the AX-ADBOX1 programming instructions. Gen. 2 interfaces can be
distinguished by a blue reset button between the (2) connectors.
AX-ADBOX1
Installing the AX-ADCH01
With the key in the off position:
• Connect the 16-pin harness with stripped leads, and the AX-ADCH01 harness, into the
interface.
• Connect the AX-ADCH01 harness to the wiring harness in the vehicle.
• If an ASWC-1 (sold separately) will be used, do not connect it until the AX-ADCH01 is
programmed and fully functional.
INSTALLING & PROGRAMMING THE AX-ADCH01
Programming the AX-ADCH01
Attention! If the interface ever loses power, the following steps will need to be performed
again. Please ensure that the owner of the vehicle knows this.
• Turn the key (or push-to-start button) to the ignition position and wait until the radio
comes on.
Note: If the radio doesn't not come on within 60 seconds, turn the key to the off position,
disconnect the interface, check all connections, reconnect the interface, and then try again.
• Turn the key (or push-to-start button) to the off position, then to the accessory position.
Test all functions of the installation for proper operation, before reassembling the dash.
Note: To use fade in amplified models, ensure the radio is turned up 3/4 of the way.
Continue to Adjusting the AX-ADCH01
REV. 6/22/2018 INSTAX-ADCH01
5