Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING !
Particular care must be taken when charging the battery because there may be leakage of acid during the charging process. Battery
acid is corrosive. If contact is made with skin or eyes, please fl ush with clean water and seek medical attention.
1.
Open recovery tank lid (25) and observe if recovery tank is empty or not. If it is not empty, empty it through drain hose. (15).
2.
Move the machine to a specifi ed charging area.
3.
Press the power switch (41) to the "off" position to turn off the machine.
4.
Only applicable to WET batteries:
Check the level of electrolyte inside the battery. If necessary, fi ll it up through the lid.
Keep all lids open.
If necessary, clean the top surface of the battery.
5.
Select one of the following procedures to charge the battery according to the model of battery being used.
TO CHARGE A BATTERY WITH AN EXTERNAL CHARGER
6.
Confi rm that the external charger is compatible. The output voltage must be DC 24V.
7.
Connect the battery connector to the external charger, and connect the external charger to an approved power outlet.
8.
When charging is complete, connect the charging connector of the battery to the machine.
TO CHARGE A BATTERY WITH AN ON-BOARD CHARGER (OPTIONAL)
9.
Remove the rubber cap at the end of the battery charging connector.
10.
Connect the end of the battery charging connector with the power supply with a charge connecting wire. (Please note whether the input
voltage of on-board charger is 110V – 120V and the output voltage 24V and frequency meet the requirements.) When the charger is
connected to the power supply, all other functions will be cut off automatically. If the red warning light on the on-board charger continues to
light, it shows that the charger is charging the battery.
11.
When the green warning light (47) is on, it shows that the battery charging process is complete.
12.
When charging is complete, remove the connecting wire from the end of the battery charging connector and the power supply, and put on the
rubber cap.
13.
Disconnect the charger wire from the power supply, and wind the wire on the reel (6).
NOTE
If more information on on-board charger (35) is needed, please refer to the charger operators manual.
SQUEEGEE CLEANING
NOTE
In order to maintain the optimal squeegee performance, the squeegee must be kept clean, and the squeegee blades must remain in
good condition.
CAUTION !
When cleaning the squeegee, it is recommended to put on protective gloves as the squeegee may contain sharp debris.
1.
Move the machine to a fl at and smooth surface.
2.
Press the power switch (41) to the "O" position to turn off the machine.
3.
Unscrew the squeegee knobs (16); remove the vacuum hose from the squeegee assembly & remove squeegee.
4.
Use the squeegee lift handle (14) to lift the squeegee mount bracket.
5.
Using a damp towel, clean the squeegee (Figure 15). Clean in particular the groove (A, Figure15) and the dirt and fragments on the vacuum
tube. Check if the front squeegee blade (C) and the rear squeegee blade (D) are intact, and if there are broken edges and cracks. Replace
them if necessary (refer to the steps in the following section).
6.
Re-install the squeegee in the reverse order of the above
12/2015
INSTRUCTIONS FOR USE
56091130 - CA30 20B
ENGLISH - A
A - 15
Publicidad
