Publicidad
Idiomas disponibles
Idiomas disponibles
READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2)
ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!
Figure 1
2. Attach Strut Tubes (#17) and Linkages (#16) to Caster Beam Assemblies (#7) as shown in Figure 2.
a) Loosen Bolts (#13) and Nuts (#28) so that Strut Tube (#17) can fit between Support Plate (#43) and Caster
Beam (#7) as shown in the Top View and Figure 2.
b) Slide one Hex Bolt (#27) through Caster Beam (#7), one Plastic Washer (#39), Strut Tube (#17), Plastic Washer
(#39), Support Plate (#43) Spacer (#36), Linkage (#16) and Locknut (#28) as shown in Figure 2 Top View.
c) Repeat on other end of Caster Beam (#7) and on second Caster Beam.
d) Tighten Bolts (#13) and Nuts (#28) securely.
e) Tighten Nuts (#28) on Bolts (#27) securely.
Note: Strut tubes must
be turned as shown or
table will not operate
16
Figure 2
7
31
7
32
correctly.
17
39
27
1. Attach Wood Bottom Board (#15) to Caster Beam
Assemblies (#7) as shown in Figure 1. Turn
Caster Beams as shown and attach board with four
Carriage Bolts (#31) and four Wing Nuts (#32).
Tighten Thumb Screws securely.
Note: Support Plate (#43)
must be on inside of Caster
Rail (#7) as shown.
15
17
28
36
3
43
32
Top View
28
36
43
39
7
13
27
16
31
7
16
17
12
13
Publicidad
