Publicidad
Idiomas disponibles
Idiomas disponibles
8. Screw U-support tube (#21) to Strut Tubes (#17) with
two Screws (#33) as shown in Figure 5. Align holes in
U-support with holes in Strut Tubes and thread screw
(#33) into hole in Strut Tube (#17) Tighten screws all
the way but be careful not to over tighten. You could
strip threads on screws if you over tighten.
9. Attach Hinges (#18) to Strut Tubes (#17) as shown in
Figure 5 and Detail B. With hinge positioned as
shown, align hole in hinge with hole in Strut Tube and
attach with ¼" Screw (#30), Plastic Washer (#38) and
Locknut (#34). Plastic Washer (#38) goes between
Strut Tube and Hinge. Tighten nut securely. Repeat for
other Hinge. CAUTION: Hinges must be
positioned exactly as shown or table will not
operate correctly and could be damaged.
DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL
BOTH TOPS ARE INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE KNOCKED OVER
CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE.
Figure 5
37
Spacer (#37) goes
between Linkage (#16)
and Leg (#19)
29
17
34
16
18
34
19
33
30
Plastic Washer goes
38
between Strut Tube
(#17) and Hinge (#18)
16
17
10. Attach Linkages (#16) to Leg (#19) as shown in
Figure 5. Pivot one Linkage (#16) up and pivot
Leg out from top and align hole in Linkage with
hole in Leg (#19). Attach Linkage (#16) to Leg
(#19) using Hex Head Bolt (#29), Spacer (#37)
and Locknut (#34). Spacer (#37) goes between
Linkage and Leg. Attach other Linkage to Leg the
same way. Tighten nuts securely.
11. Attach Corner Protector (#40) to table corners.
Push snap tabs on Corner Protector into holes in
rails. Be sure that tabs are aligned with
holes before pushing. You could break tabs if
they are not aligned correctly.
12. With at least two adults, repeat steps 7
.
through 11 for other table top assembly.
37
34
19
16
34
21
38
30
18
6
40
ATTENTION: If hinge is positioned as
shown below (Detail A), flip the hinge as
shown in Detail B. Do not unscrew from
the table.
18
29
Incorrect position
of hinge
CAUTION: Hinges must be positioned
exactly as shown or table will not operate
correctly and could be damaged.
Detail B
33
30
18
Correct position
of hinge
Detail A
17
34
38
17
Publicidad
