Publicidad
Idiomas disponibles
Idiomas disponibles
the tank cover. Remove any accessories, which may have been shipped in the tank. Refer to the assembly
section before replacing the tank cover on the large and small tanks.
CASTER SYSTEM
You will find four casters, two caster feet, one basket and four screws with your wet/dry vacuum.
1. With cord disconnected from receptacle and tank cover removed, turn tank upside down so
that the bottom is facing up.
2. Take basket and place into slots (on rear of tank opposite of drain). Secure
with screws provided.
3. With tank drain facing you, take caster foot marked with the letter A and
place in slot on left side of tank also marked with the letter A. Secure with
screw provided.
4. Take caster foot marked with the letter B and place in slot on right side of
tank also marked with the letter B. Secure with screw provided.
5. If flat washers are included in hardware package place flat washer over stem of caster before installing
casters into feet or basket. NOTE: Flat washers are not required with all units.
6. Install casters into caster feet and basket by inserting the
caster stems into the holes provided. Apply pressure and
twisting motion until casters snap into place.
DANGER
like that tend to produce arcs or sparks that can cause an explosion. Do not pick up flammable,
combustible, or hot materials. Do not use around explosive liquids or vapors, as electrical devices
produce arcs or sparks which can cause a fire or explosion - do not use at filling stations or
anywhere gasoline is stored or dispensed.
1. When using the portable vacuum the filter must be installed on the portable vacuum tank cover. For
the large capacity vacuum the filter must be installed on the large tank cover. For additional filtration
the filter may also be installed on the portable vacuum tank cover. Refer to the filter installation and
maintenance section to make sure the correct filters are installed for your cleaning operation.
2. Replace tank cover on the large tank and apply pressure with thumb to each latch until it snaps tightly
into place. Make sure each latch is clamped securely. Replace the tank cover on the small tank by
aligning the tabs with the lugs. Press down firmly on the upper housing until the tank cover snaps into
place. Make sure the cover is secured.
UNPACKING (CONT'D.)
ASSEMBLY
SET UP AND OPERATION
–
This equipment incorporates parts such as switches, motors or the
Caster
Foot
Caster
Caster
Foot
Screw
Screw
Caster
Foot
PAGE 5
Publicidad
