Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP AND OPERATION (CONT'D.)
3. To use the portable vacuum follow these instructions.
a. Insert machine hose end of the non-locking hose into inlet of the small tank. Twist
slightly to tighten the connection.
b. Attach one of the cleaning accessories (depending on your cleaning requirements)
to the accessory end of hose. Twist slightly to tighten the connection.
c. Plug the cord into the wall outlet. Your portable vacuum is ready for use.
I = ON, O = OFF
4. To use the large capacity vacuum follow these instructions.
a. Place portable vacuum in the cradle of the large tank cover. Slide the side securement arms in an
inward motion. Apply pressure to each securement arm until it snaps tightly in place. Make sure both
securement arms are clamped securely.
b. Insert machine hose end with locking-nut into inlet located on the front of the
large tank. Turn locking nut to tighten. Do not over-tighten.
c. Attach the extension wands to the accessory end of the hose. Twist the wands
slightly at each connection to secure them into place.
d. Attach one of the cleaning accessories (depending on your cleaning
requirements) onto the extension wands. Twist the accessory slightly to tighten
the connection. NOTE: Many more useful tools are available at your local
dealer or the Shop-Vac
e. Plug the cord into the wall outlet. Your large capacity vacuum is ready for use.
I = ON, O = OFF
FILTER INSTALLATION AND MAINTENANCE
DRY PICK UP OPERATION
NOTE: Never use the vacuum for dry pick up without a dry use filter installed. Using the vacuum without a
filter will cause dust to discharge from the blower port and cause damage to the motor.
WARNING
BEFORE REMOVING THE TANK COVER.
Follow the instructions for the filter that came with your vacuum. Some filters mentioned do not come
standard with all vacuums. Additional filters are available at your local dealer or the Shop-Vac
CARTRIDGE FILTER
The cartridge filter can be used for dry pick up and small quantities of wet pick up. Installation is the same
for both. When picking up fine dust or powders a high efficiency filter bag must be used with the cartridge
filter.
If a foam sleeve is installed on the lid cage, remove it by sliding it off the lid cage. NOTE: If the cartridge
1
filter has been used for wet pick up, it must be cleaned and dried before using it for dry pick up.
2. With the tank cover in an upside down position, slide the cartridge down over the lid
cage, pushing until the filter seals against the cover.
. Place the filter retainer into the top of the cartridge filter. Hold the tank cover with one
3
hand, turn the handle on the filter retainer clockwise to lock the filter into place.
PAGE 6
website.
®
–
ALWAYS DISCONNECT THE PLUG FROM THE WALL OUTLET
®
website.
Publicidad
